Business Owner Faces Prison After Worker Is Electrocuted
The electrocution death of a worker could send the owner of a painting business to prison.
The U.S. Attorney’s office for the Western District of Pennsylvania has filed one criminal charge against Thomas Caruso, 77, owner of Modern Painting & Decorating of New Kensington, PA. Caruso is charged with willful violation of safety regulations that caused the electrocution of an employee.
The charge comes with maximum penalties of six months in prison, a $250,000 fine and one year of supervised release.
More Cities Adopt the Washington Cities Electrical Code
Are your Electrical Specifications Ready for the Washington Cities Electrical Code?
The Washington Cities Listed below have or will soon be adopting a new set of Electrical Codes. The Washington Cities Electrical Code will be used to supplement the National Electrical Code (NEC). The date that each city will be adopting the code will vary. The following are the cities that have adopted the new code.
Bellevue
Bellingham
Burien
Des Moines
Kirkland
Marysville
Mercer Island
Normandy Park
Renton
SeaTac
Tukwilla
Cities who are involved and may be adopting this Code are:
Redmond
Vancouver
Seattle
Longview
Section 110.16 of the new Washington Cities Electrical Code (WACEC) states that arc flash labels shall be attached to electrical equipment. The labels must contain the Hazard Risk Category (HRC) and the Arc Flash energy level (cals/cm2). This requirement goes above and beyond the Section 110.16 of the NEC. The NEC allows generic Arc Flash labels warning only that there is a hazard. The Washington Cities Electrical Code (WACEC) will not allow generic Arc Flash labels.
Arc Flash energies are based upon the available fault current at each piece of equipment and the time that it takes for the upstream device to operate (trip or blow).
SAMPLE ARC FLASH LABEL
An arc flash study can be performed only after:
- Utility information is known
- Transformer Size and Impedance
- Primary Protection (Mfg, Type, & Size)
- Minimum and Maximum available Primary Fault Current
- Protective device data (Mfg, Type, & Size) to be installed or is already installed has been collected.
- Protective Device Coordination Study (breaker and relay settings) has been completed.
Proper specifications are extremely important to the success of any project. Detailed Power System Study (Short Circuit, Protective Device Coordination, & Arc Flash) specifications will help to ensure the studies are performed accurately. These studies must be preformed before the equipment is to be energized.
To assist you with this new requirement, we have created Power System Study Specifications. These will help you and your company avoid many of the common pitfalls when specifying these important studies. Please feel free to use these specifications for your projects.
